MPLS Configuration on Cisco IOS Software by Lancy Lobo, Umesh Lakshman
MPLS Configuration on Cisco IOS Software Lancy Lobo, Umesh Lakshman ebook
ISBN: 1587051990, 9781587051999
MPLS Configuration on Cisco IOS Software is a complete and detailed resource to the configuration of Multiprotocol Label Switching (MPLS) networks and associated features. The following example identifies a Cisco product that is running Cisco IOS Software Release 12.3(26) with an installed image name of C2500-IS-L: Router#show version Cisco Internetwork Operating System Software IOS (tm) 2500 Software ( C2500-IS-L), Version 12.3(26), RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2008 by and MPLS TDP/LDP to properly establish connections over an affected interface. Describing Access Technologies Introducing Service Provider Access, Edge, and Transport Technologies Configuring Basic BGP. Free Cisco Training & Resources -certification Exam Preparation. Introducing the Cisco IOS XR Configuring Basic Routing Configuring EIGRP Understanding Cisco Router Security. Applying Access Control Lists Transitioning to IPv6. C6500#sh ver | in IOS|Compiled Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXH7, RELEASE SOFTWARE (fc3) Compiled Thu 11-Mar-10 20:31 by prod_rel_team C6500# End with CNTL/Z. In recent months I seem to have hit a lot of bugs in Cisco software. ACLs and IP Address Translation. Class-based policing can set the IP Precedence, DSCP, MPLS EXP, Frame Relay DE, or ATM CLP of a packet based on rate-limiting measurements, as shown in Example 3-6. Cisco IOS XE and Cisco IOS XR Software. In the ever exploring world of networking, Its nice Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide. Class-based marking was CEF dependent in early Cisco IOS transmit exceed-action set-clp-transmit violate-action drop. Class-based marking, introduced in Cisco IOS Software Release 12.1(2)T, is an MQC-based syntax that uses the set command within a policy map to mark packets, frames, cells, or labels. The second major change is the introduction of a new configuration policy language known as CPL. Across the board on the main software releases of IOS, NX-OS or IOS-SX I seem to be hitting a wide range of bugs, and some of them are pretty stupid.